Using the Radio Shack at OH73ELK
Please check the antenna connector. If it is unplugged (like on the picture below), please connect it to the SWR and POWER Meter jack.
Then you need power, so insert the black plug into the socket under the table (see next picture ):
Then, turn ON the general switch on the table (see next picture):
NB: Please switch OFF the general switch every time you have finished operating.
If you are not familiar with the Icom 7300 transceiver, please read the official manual which is on the table (you also have a special guide to the Icom IC -7300 by Andrew Barron,ZL3DW). Turn on the transceiver. The RF power of the transceiver can be set here (see next picture - you habe to PUSH this button):
NB: The IC 7300 is a touch screen / menu-driven transceiver. If you are not familiar with this technology, please read the manual.
Here is one important example: Do not look for a band switch. In order to switch bands, push the touch screen here:
VERY IMPORTANT: always set the antenna to the appropriate band with the switch RQUAD “RU-005A” (you can see RQUAD “RU-005A” switcher on next picture):
You just need to press one of red buttons, do not press button "F".
Every time you change bands, you need to check and/or switch the antenna!
The following antennas are available:
- Red button 1: Fullsize Yagi beam for 20-15-10m
- Red button 2: GP 40m (works also on 20 m, we use it as RX-ANT for 20 m)
- Red button 3: Inv-V for 80 m (works also on 17 m, also as TX-ANT)
- Red button 4: Inv-V for 30 m (near parkplace)
- Red button 5: Inv-V for 30 m (between house and lake - here we will inslall an Inv L for 160 m in future)
As mentioned before, every time you stop working, please turn off the general switch. This also switches the antennas to ground! This is very important for protection against static electricity and thunderstorm hazards. If you stay during summer when thunderstorms are possible, please carefully disconnect the antenna from the SWR and POWER Meter upon departure or during thunderstorms.
Yaesu rotor G-1000DX
The rotor is centered NORTH and allows to turn the 10/15/20 beam through 360 degrees. The rotor has a certain "overlap" capacity going beyond 360 degrees.
Please use extreme care when using this rotor and DO NOT OVERLAP across NORTH.
(For example: when turning the antenna from NORTH to SOUTH or EAST, rotate COUNTER-CLOCKWISE ("left"). When going back towards NORTH, rotate CLOCKWISE - "right").
During the winter season, at temperatures below -5 degrees, please use the rotor as little as possible.
If the temperature drops below –10 ° C DO NOT USE THE ROTOR (such temperatures are outside the working range of this Yaesu rotor).
In this situation, you can use the GP 40m/20m (Red button 2) This GP is also working on 20 m band!
Please do not change the antenna rotation speed. It is set in the middle position.
Headset / footswitch
The station works very well with the current setup. Please do not change the wiring or add peripherals without the consent of Alex.
In case you need to use the headset Heil BM-10 iC and footswitch Heil FS-3, please inform Alex before your arrival.
Leaving the station
At the end of your stay, please carefully disconnect the antenna from the SWR and POWER Meter, turn OFF the general switch and disconnect all plugs from the sockets.
Obviously, you should also disconnect the antenna during your stay whenever thunderstorms are approaching.
The shack is equipped with an amplifier (under the shack table) and a remote control unit (on the shack table).
Do not use this equipment without prior authorisation by Alex. Without proper introduction and briefing, the use of the amplifier equipment is dangerous and can lead to extensive damage.
Also, even if they look interesting, never touch any controls on the amplifier.
There is a special separate instruction for use of Amplifier.
3 General remarks
Please always use sound judgment concerning safety issues. In case of doubt, think twice.
Do not even think about climbing the tower or similar activities.
If you want to erect your own antennas, please check beforehand with Alex.
Enjoy your stay at OH73ELK!Download PDF